Ess and hold the Arm/Disarm button to cycle through the six siren sounds.
7 Setting Motion Sensitivity The defcon 3 alarm dreamweaver cs3 ebook pdf unit has two sensitivity settings: Low Motion Sensitivity (Level 1 First then.
If the alarm does not receive a signal from the remote control for.Insert the batteries in place as shown in Figure.To activate the alarm unit, you must first transmit a signal from its remote control device.Contents, defcon 3 alarm unit, defcon 3 remote control (with ansi/neda 1811A, or equivalent, battery installed) 3 AAA Alkaline batteries (for use with alarm unit).You are now in Program Mode.Ess and hold the Arm/Disarm button to cycle between the two volume settings.PA400U / A 30 # defcon 1 Ultra, hereafter, addresses as defcon.
Bypass the other features and program the alarm siren sound, press and hold the Program button three times.
Problem Solution System does not operate Ensure batteries are properly installed in both the remote control and the alarm unit; battery cover screw is in place; cable is inserted completely; check/replace batteries.
Remove the screw and battery cover from the back of the alarm unit.You will hear one chirp, and the left LED ligh.Installing Batteries in the Alarm Unit.To activate the alarm siren, simultaneously press and hold both buttons on the remote control.This setting triggers the alarm siren when the unit has detected continuous motion for six seconds.