(DHW).8.3.3 mbar m3/h CH temperature flow range C (for 20 C rise) l/h Pump pressure available.25 (25).25 (25).25 (25) bar (KPa).75.75.75 bar DHW flow rate at factory set temperature rise (T 42 C) Mains water pressure.
16.4 Install the flue system.
This fault code will usually be displayed after you experience a boiler lockout, and dx-ball you have no supply of heating or hot water.
Turn the boiler off and rapidly drain both boiler and system while still hot.2.2.1 For thermocompact 615, 637 and turboMAX plus 837 Remove the flue gas connector (2a) on the fan.For optimum fuel economy it is recommended that where TRVs are used they are used in conjunction with a programmable room thermostat heating or separate dx-ball timer and room thermostat to dx-ball ensure complete boiler shut down when the heating demand is satisfied.Connect the flue system to central the boiler.5.18 Instructions for Installation and Servicing turboMAX plus and thermocompact R1 23 5 Boiler Installation Sequence Connection details for control systems utilising 2 x 2 port motorised valves via external wiring centre/junction box Diagram only applies to the specific controls mentioned 3 amp fused main.Press button until P3 (mid setting point) is shown in display.GB, table of Contents, page 1 List of Contents.Connect the central heating pipework servicing to the flow (9) and return (4) tails.BS 6891: Specification for installation of low pressure gas pipework up to 28 mm (R1) in domestic premises (2nd family gas).The information given in this booklet will enable you to obtain the best performance from your boiler.After completion of these tests tighten the sealing screw and check all joints and test points for soundness. This frost thermostat should be connected across the boiler terminals 3 and 4, in parallel with any external heating controls.
Both should be recorded in the Benchmark gas boiler commissioning checklist.
Record appliance working gas inlet pressure (mbar) in the Benchmark Installation, Commissioning and Service Log Book.
No receipt will be issued.
Release water central heating boilers vaillant servicing manual from the system until the system design pressure.0 bar is attained.